Werbung
ELKC022VA
ELKC022VA
Mini Insect Destroyer
Mini Insect Destroyer
Operating instructions
Operating instructions
Read carefully before use
Read carefully before use
Thank you for purchasing the ELECTRIS INSECT DESTROYER.
Thank you for purchasing the ELECTRIS INSECT DESTROYER.
We are confident that this device will give complete satisfaction.
We are confident that this device will give complete satisfaction.
Warning:
Warning:
Electric protection class: Class II
Electric protection class: Class II
Degree of protection against humidity: IPX0
Degree of protection against humidity: IPX0
This equipment can be used by children aged 8 years and over and by
This equipment can be used by children aged 8 years and over and by
persons with reduced physical, sensory or mental abilities or without
persons with reduced physical, sensory or mental abilities or without
experience or knowledge, if they are properly supervised or if instructions
experience or knowledge, if they are properly supervised or if instructions
on the safe use of the equipment have been given to them and the risks
on the safe use of the equipment have been given to them and the risks
involved have been understood. Children should not play with the device.
involved have been understood. Children should not play with the device.
Cleaning and maintenance by the user must not be carried out by
Cleaning and maintenance by the user must not be carried out by
unattended children. Never immerse the device in water.
unattended children. Never immerse the device in water.
It must be kept out of the reach of children by fixing it at a height of
It must be kept out of the reach of children by fixing it at a height of
at least 2 meters from the ground
at least 2 meters from the ground
below the device. Stabilise it at a height
below the device. Stabilise it at a height
using the metal ring. Always keep the
using the metal ring. Always keep the
device, cord and plug away from
device, cord and plug away from
moisture. Do not hang or lift the unit by the power cord, always use the
moisture. Do not hang or lift the unit by the power cord, always use the
provided suspension. At the slightest incident, unplug your device.
provided suspension. At the slightest incident, unplug your device.
The device can only be used indoors: use in barns, stables and
The device can only be used indoors: use in barns, stables and
similar premises is not considered as indoor use. Do not use in a bathroom.
similar premises is not considered as indoor use. Do not use in a bathroom.
It must not be used in areas where flammable vapours or explosive dust are
It must not be used in areas where flammable vapours or explosive dust are
likely to be present.
likely to be present.
If the power cord is damaged, it must be replaced by the manufacturer, its
If the power cord is damaged, it must be replaced by the manufacturer, its
After-sales department or any other similarly qualified person in order to
After-sales department or any other similarly qualified person in order to
reduce the risk of electric shock.
reduce the risk of electric shock.
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
This insect destroyer effectively eliminates flying insects WITHOUT CHEMICALS.
The light emitted by the two ultraviolet tubes attracts insects to the internal high
The light emitted by the two ultraviolet tubes attracts insects to the internal high
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
voltage mesh (1000 V at a few milli-Amperes) to electrocute them.
4
4
RESPECT THE HEIGHT OF
RESPECT THE HEIGHT OF
AT LEAST 2 METRES
AT LEAST 2 METRES
Maintenance:
Maintenance:
Before any intervention, disconnect the device
Before any intervention, disconnect the device
and leave it to cool for about 15 minutes.
and leave it to cool for about 15 minutes.
Keep the device in a dry, ventilated,
Keep the device in a dry, ventilated,
dust-free place.
dust-free place.
Clean the dead insects off the wire
Clean the dead insects off the wire
mesh using a small brush at least once a week.
mesh using a small brush at least once a week.
In the lower part of the insect destroyer,
In the lower part of the insect destroyer,
a removable container collects the insects.
a removable container collects the insects.
This container must be emptied and cleaned at least once a week, to do
This container must be emptied and cleaned at least once a week, to do
this, unscrew the two small screws and remove the container.
this, unscrew the two small screws and remove the container.
Changing the neons (tubes):
Changing the neons (tubes):
Check that the device is disconnected.
Check that the device is disconnected.
Remove the two screws
Remove the two screws
at the bottom of the device.
at the bottom of the device.
Unscrew the two neons. Fit
Unscrew the two neons. Fit
the two new neons.
the two new neons.
Replace the cover securely
Replace the cover securely
and retighten the screws.
and retighten the screws.
Getting started:
Getting started:
Unpack the product.
Unpack the product.
Once the insect destroyer is installed, connect the power cord located at
Once the insect destroyer is installed, connect the power cord located at
the back to a 230V power outlet and press the on/off switch (I/0).
the back to a 230V power outlet and press the on/off switch (I/0).
When switched on, the tubes emit a bluish "ultraviolet type" light. Flying
When switched on, the tubes emit a bluish "ultraviolet type" light. Flying
insects are attracted to this light and touch the electric grid. The contact of
insects are attracted to this light and touch the electric grid. The contact of
the insect with the grid electrocutes it and can sometimes cause small
the insect with the grid electrocutes it and can sometimes cause small
sparks.
sparks.
Risk of electrical shock
Risk of electrical shock
Specifications:
Specifications:
Power cord: 1.2 m
Power cord: 1.2 m
2 x 2 Watt fluorescent tubes
2 x 2 Watt fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 Electronic ballast for fluorescent tubes
1 High voltage electronic circuit
1 High voltage electronic circuit
reference: ELKC022VA-TU
reference: ELKC022VA-TU
SPARE LAMP
SPARE LAMP
Type : fluo compacte
Type : fluo compacte
Dimension : Ø15mm, long. 160 mm
Dimension : Ø15mm, long. 160 mm
Puissance : 2 W
Puissance : 2 W
Culot : T4
Culot : T4
Éclairage UV
Éclairage UV
Coverage area: about 20m2
Coverage area: about 20m2
Direct power supply 230 Volts ~ 50/60 Hz
Direct power supply 230 Volts ~ 50/60 Hz
Total consumption: 1,1 Watts
Total consumption: 1,1 Watts
Weight / Dimensions: 380 g - 15x23x10 cm
Weight / Dimensions: 380 g - 15x23x10 cm
5
5
Werbung
