Care And Maintenance - Aiwa GBTUR-120BK Bedienungsanleitung

12
en
BLUETOOTH OPERATION
IMPORTANT:
Prior to use Bluetooth function, your turntable should be paired firstly with your Bluetooth device.
("Pairing" means establish connection between Bluetooth devices such as MOBILE PHONE, TABLETS,
PC, ETC).
1. Lift up the tonearm and put it on the rest.
Then press the MODE/REC button to
switch into the Bluetooth mode.
(fig. 1)
In Bluetooth mode, the turntable will
2.
search automatically for Bluetooth
devices.
3. Turn on Bluetooth functionality on your
device and make it discoverable (see your
devices instructions to add or setup a
Bluetooth device).
Search for Bluetooth equipment:
4.
, that's your turntable's
aiwa GBTUR-120
identification.
(fig. 2)
A sound indication will announce that
Bluetooth devices are successfully
paired. (During the paring, if a password is
required, you need to input code"0000").
Your Bluetooth device stores the turntable
unique identification at the same time.
Notes:
• Under this function, the turntable function will be stopped automatically.
• The Bluetooth reproduction can be controlled by the use of the Bluetooth device, or the turntable's
buttons.
• The effective range of Bluetooth devices is 10 meters. Once paired, your device should connect
to the GBTUR-120 .
• This unit supports iPad, Samsung, HTC, Motorola, Nokia, and other Bluetooth devices wirelessly
transmitting audio.

CARE AND MAINTENANCE

REPLACING THE STYLUS
Push the arm lock to release the tonearm.
1.
2. Take off cap of cartridge to expose the
needle out.
Take off the audio-line from the cartridges
3.
completely.
4. Separate the cartridge from the socket
lightly.
5. To fit a new one just in opposite deals,
insert the audio-line accordingly, and
install the cartridge to the socket lightly.
(fig. 1)
(fig. 2)
Notes:
• Please exercise extreme care whilst replacing the stylus so as to avoid the tonearm and
audio line wires from any damage.
• Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from
back to front of the cartridge).
• We would also point out that for the same reason your stylus should be replaced periodically
(approximately every 250 hours).
MAINTENANCE OF VINYL RECORDS
It is recommended to clean the discs
1.
before and after listening.
2. Clean your discs periodically with a soft
anti-static cloth, you can also moisten it
with cleaning fluid.
3. Always clean the discs in circular motions
following the direction of the grooves.
4. While cleaning, place it on a clean, soft
cloth on a flat surface, it is also advisable
to use a special mat and cleaning kit.
5. Never use detergents or abrasive cleaners
to clean the disc.
6. Discs should be stored in their sleeves
after each use to avoid damage.
7. Never store the discs supported diagonally
or flat!
Always keep the discs in a vertical position
to avoid deformation.
8. Do not expose discs to direct sunlight, high
humidity, high temperatures, or dust, etc.
Prolonged exposure or extreme temperatures
can warp the disc.
Do not stick or write anything on either
9.
side of the disc.
Sharp writing instruments or the ink
would damage the surface.
TRANSPORTING THE UNIT
When transporting your record player do
not forget to:
-
Replace the protective cap on the stylus.
-
Put the rest clip into the pick-up arm.
13