6
Fan options
1. Loosen the plastic screw driver
from its brackets.
2. Open the lid to set the humidity
sensor set point
delay time
.
Only use the included plastic screw
driver for adjustment operations to
avoid damage to the circuit board.
7
Humidity sensor
Turn the control knob clockwise to
increase the humidity sensor set
point
. Turn counter-clockwise to
decrease it. Adjustable from 60% to
90%.
8
Turnoff delay time
Turn the control knob clockwise to
increase the turn-off delay time
Turn counter-clockwise to decrease
it. Adjustable from 2 to 30 minutes.
Care & maintenance
9
Attach device cover
After setting, close the lid and at-
tach the cover to the device. Make
sure the cover has snapped into the
and turn-off
latch at the bottom of the fan.
10
Switch on the circuit breaker
11
Care & maintenance
Disconnect the fan from
power mains prior to any
operations on the device.
Always check the integrity of the
device.
Remove the cover from the device
by unlifting it from the latch. Clean
the cover under running water. Use
a soft clean brush to clean the im-
.
peller. Wipe the fan surfaces dry.
Clean at least once per 6 months.
Do not allow water or liq
uid come into contact with
electric components!
GB
103