Handlebar Adjustment - Work Position; Pad Assembly; Suction Bag Assembly - Fimap FM 1500 S Handbuch

HANDLEBAR ADJUSTMENT – WORK POSITION
Before you start working with the machine, you will need to find the correct work position. To do this,
press the tilt adjustment lever, release it until your arms are slightly bent and as low as possible, while
keeping the back straight and the legs slightly apart.
When working the operator is behind the machine.

PAD ASSEMBLY

To insert the brush:
1.Make sure the power supply cable is unplugged from the mains socket
2.Make sure that the handlebar is in rest position (vertical compared with the machine)
3.Tilt the machine until bringing the handlebars down to the ground, by putting a foot into the rear of
the base body
4.Use the supplied handle (1) to loosen the male center lock (2) by turning it counter clockwise.
5.Place the pad onto the pad holder (3).
6.Keep the pad in position with one hand, screw the male center lock and then lock it using the handle.
WARNING: you are advised to always wear
protective gloves, to avoid the risk of serious injury to
your hands
SUCTION BAG ASSEMBLY (VERSIONS V)
To insert the suction bag:
1.Make sure the power supply cable is unplugged from the mains socket
2.Make sure that the handlebar is in rest position (vertical compared with the machine)
3.Lift the bag cover (1) up
4.Insert the collection bag (2) into the suction coupling (3) having care not to damage the cardboard
support of the bag.
5.Refit the cover making sure that the bag is completely inside without being squashed by the cover's
rims
25