Safety; Maintenance; Environmental Protection; Troubleshooting - B+BTec Diamond3 405TS Bedienungs- Und Sicherheitshinweise

GB
completely .

8. SAFETY

Besides the valid safety regulations atten-
tion to the following items should be made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine .
• Carefully check that the electrical con-
nections are correct .
• Electrical cables should not come in
contact with water or water spray .
• Damaged saw blades should be
replaced immediately .
• Secure material to be cut by hand dur-
ing sawing .
• Make sure your hands stay away as
far as possible from the rotating saw
blade .
• Wear protective goggles during saw-
ing .
• Wear hearing protection during saw-
ing .

9. MAINTENANCE

• The cooling water should be replaced
and/or replenished regularly .

11. TROUBLESHOOTING

For malfunctions that are not specified in
this chapter, when in doubt or when explic-
itly indicated, seek assistance from an
authorized service facility.
DIAMOND3
405TS-406TS
®
• It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis. For example,
place the pomp in a bucket of clean
water after the sawing job and run the
machine for a minute or so . This also
guarantees a longer lifetime of the
pump .
• When the machine is not used for a
longer period, the pump should not
remain in the muddy cooling water .
Cleaning the pump as described
above and leaving it outside the water
container is better .
• Regularly check the saw flanges for
wearing out and replace if necessary .
10. ENVIRONMENTAL
PROTECTION
Do not dispose of the appliance
with domestic waste . Dispose of
the appliance only via an author-
ized waste management com-
pany or your municipal waste
management organisation . Adhere also to
the applicable regulations . In case of
doubt refer to your waste management
organisation . Recycle all packaging mate-
rial in an environmentally friendly manner .
20