Technical Features - FLAMEN Port A Suction Bedienungsanleitung

GB

TECHNICAL FEATURES

UNIT
Reciprocating twin-cylinder piston compressor, designed for use without lubrication. The housing is made
of metal painted with epoxy powders.
Voltage:
Power:
Adjustable vacuum level:
Max air flow:
Dimensions:
Weight:
Sound level (at 1 m):
Intermittent use:
Operating requirements:
Storage requirements:
Operating/storage
atmospheric pressure:
Internal battery:
Battery autonomy:
In compliance with Directive 93/42/EEC
Disposal: In conformity with Directive 2002/96/EC, the symbol shown on the appliance to be disposed
of indicates that this is considered as waste and must therefore undergo "sorted waste collection". The
user must therefore take (or have taken) the above waste to a pre-sorted waste collection centre set up
by the local authorities, or else give it back to the dealer when purchasing a new appliance of the same
type. Pre-sorted waste collection and the subsequent treatment, recovery and disposal operations favour
the production of appliances made of recycled materials and limit the negative effects of any incorrect
waste management on the environment and public health. The unlawful disposal of the product by the
user could result in administrative fines as provided by the laws transposing Directive 2002/96/EC of the
European member state in which the product is disposed of.
Warning: follow the "Instructions for use"
Switch "OFF" (or battery recharging)
Clockwise - Higher vacuum value
Counterclockwise - Lower vacuum value
Classe II unit
Sterilization by means of ethylene oxide
Electromagnetic compatibility
This suction unit is designed to meet the current requirements for electromagnetic compatibility. However,
if you suspect that the unit is interfering with the operation of your TV, radio or other electric appliance,
try relocating the unit until the interference ceases or plugging the unit into a different power socket during
the battery recharge mode.
The Manufacturer, the Retailer, the Importer are responsible for safety, reliability and performance of the unit
only if:
- the unit is used following the instructions for use;
- the electrical system of the facility where the unit is used is in accordance with IEC Standards;
- assembly, additions, re-calibrations, changes or repairs are carried out by authorised personnel.
The Manufacturer reserves the right to make technical changes to this product without prior notice.
12 V
- - -
3 A
from -0.16 to -0.81 bar approx
20 l/min approx
37 x 10 x 24 cm
5.6 Kg
65 dB (A) approx
30 mins. ON/30 mins. OFF
(when operating through cigarette-lighter
cord or multivoltage power supply unit)
temperature min. 0°C; max 40°C
air humidity min. 10%; max 95%
temperature min. -15°C; max 50°C
air humidity min. 10%; max 95%
min. 690 hPa; max. 1060 hPa
2x6V DC 3Ah Lead air-tight
30 mins. approx.
0051
SYMBOLS
- - -
Direct current
Switch "ON"
Alternating current
Medical Marking ref. 93/42/EEC Directive
0051
Do not use the unit while having a bath
or a shower
EXHAUST
Disposable
P O W E R L E A D F R O M
C I G A R E T T E L I G H T E R
CODE 07261A0
In case of breakage of fuse,
replace with a 5A - 250V
approved fuse, rapid, having
dimensions Ø 6.3 x 30 mm,
unscrewing the end of the
plug that must be fitted in the
cigarette-lighter socket.
MULTIVOLTAGE POWER
SUPPLY UNIT - SWITCHING
CODE 09818
(Model: SA165A-1250U-3)
Primary: 100-240V ~ 50/60Hz
Secondary: 12V
- - -
Dimensions: 12 x 6 x 4 cm
Weight: 300 g
Type B unit
LATEX Latex Free
10