Setting The Speaker Setting; Correcting The Subwoofer's Phase - Pioneer DEQ-P7000 Bedienungsanleitung

Section
Audio Adjustments
02
1 Press AUDIO to select DolbyPL.
Press AUDIO until DolbyPL appears in the
display.
2 Press 5 to turn the Dolby Pro Logic on.
DolbyPL ON appears in the display. Dolby Pro
Logic is now on.
• You can turn off Dolby Pro Logic by pressing
∞.
Note
• When playing a 2-channel mono source with
Pro Logic switched on, there may be occa-
sions when the following will occur:
No audio is outputted if the center speaker
setting is SMALL or LARGE while no center
speaker is installed.
Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.

Setting the speaker setting

You need to make with/without (or yes/no) and
size (bass reproducing capacity)
selection/adjustments depending on the
installed speakers. The size needs to be set to
LARGE (large) if the speaker is capable of
reproducing sounds of about 100 Hz or below.
Otherwise select SMALL (small).
1 Press AUDIO and hold until SP Set
appears in the display.
2 Press 2 or 3 to select the speaker to be
adjusted.
Each press of 2 or 3 selects the speaker in the
following order:
Front speakers—Center speaker—Rear speak-
ers—Subwoofer—S.W (subwoofer setting)
10
En
• You can switch to the S.W, only when the
subwoofer has been set to ON.
3 Press 5 or ∞ to select the correct size for
the selected speaker.
Press 5 or ∞ until the desired size appears in
the display.
LARGE (large)—SMALL (small)—OFF (off)
• You cannot select OFF, when the front speak-
ers have been selected.
• You can switch ON or OFF, when the sub-
woofer has been selected.
• You can switch Rev. (reverse phase) or
Normal (normal phase), when S.W (subwoofer
setting) has been selected.
4 Press BAND/ESC to return to the playback
display.

Correcting the subwoofer's phase

If trying to boost the bass output of the sub-
woofer doesn't do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofer's output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Press AUDIO and hold until SP Set
appears in the display.
2 Press 2 or 3 to select the subwoofer.
Press 2 or 3 selects the speaker in the follow-
ing order:
Front speakers—Center speaker—Rear speak-
ers—Subwoofer—S.W (subwoofer setting)