Werbung
4.Clip Indicator
Ein clip indicator (Trimmindikator) leuchtet auf, wenn
die Ausgangsverzerrung 1% ubersteigt.
5.Signal Indicator
Ein Signalindikator leuchtet auf, wenn die Ausgan-
gsverzerrung 2V RMS ubersteigt
6.8 Regler um die Lautstarke zu regeln.
7.An/ Aus Schaller
8.Diese Locher dienen zur einfachen
Transportierung des Gerates mit
Halterungen.
4.Clip indicator
A channels CLIP indicator lights up when its output
distortion exceeds 1%(i.e.,clipping).Output signal
clipping is typically caused by excessive input signal
levels.
5.Signal indicator
A channels SIGNAL indicator lights up when its output
exceeds 2 V rms,.which is equivalent to 1/2watt into 8
ohms,or 1 watt into 4 ohms.
6.Attenuators
These detentedcontrols are used to attenuate the
input signal from MIN to MAX for each channel. In
Bridge mode,only the attenuator of the first channel
in the pair is active,i.e.,channel A of pair A-B,channel
C of pair C-D,channel E of pair E-F, and channel G
of pair G-H.
7.Power switch
Use this switch to switch your power amplifier on.
8.Handles Installing
Werbung
