Appliance Description And Endowed Accessories; Use; Cleaning - Collexia F1301 Bedienungsanleitung

APPLIANCE DESCRIPTION AND ENDOWED
ACCESSORIES
1. Power cord
2. Technical data
3. LED indicator
4. On and off button
5. Heating plates

USE

Never operate the appliance without supervision.
During operation, only place the device on heat-
resistant surface. Improper or too frequent use of the
device can cause hair damage. Follow the operating
instructions!
Preparation of the hair
• Wash the hair thoroughly before using the hairstyler. Doing so
allows to gain the best results.
• Rinse the hair well to remove shampoo residue. A final rinse with
cold water provides additional sheen.
• Dry your hair with a hairdryer. Always finish the drying process
with a stream of cold air to maintain the hair surface smooth and
glossy. Appliances with a cold air (cold shot) button are ideal for
this purpose.
MI001247_F13.indd 13
Adjusting and switching on the device
Risk of burns! Avoid direct skin contact with the hot
plates.
• Connect the power cord (1) to the mains; set
switch (4) to the "ON" position and let the hair
straightener heat up.
• A led light (3) comes on to indicate that the
appliance is switched on; the temperature set
for the straightener is 200°C.
• Take a small lock of hair, of the same size as the straightener (5)
between your fingers and place it firmly between the two plates.
• Hold the lock taut with one hand, close the straightener and slide
it down from the roots to the tips with the other hand.
• When you have finished, switch off the appliance and disconnect
the plug (1) from the socket.
N.B.:
While you are using the appliance, you may notice some steam
coming out, which is excess moisture in the hair that soon
evaporates.
WARNINGS
This appliance is not suitable for curling hair, so it must never
be rotated when being used.

CLEANING

ATTENTION: Before cleaning the device, switch it off
and pull the power plug from the socket!
7
05/07/13 18.31