Equalizer Control; Subwoofer Setting; Installation; Before Installation - Blaupunkt AMSTERDAM 290 BT Bedienungs- Und Montageanleitung

Controlling Audio

Equalizer Control

1
Press the < > button.
2
Touch [Settings].
3
Touch [Audio].
4
Touch [Sound Effect].
5
Set each item as follows.
1
2
1 You can select frequency bar and adjust its level.
(-7 to +7)
• The adjustments are stored and "User" is activated.
2 To recall the preset equalizer curve.
3 The "User" preset and the current EQ curve returns
to flat.
Subwoofer settings
1
Press the < > button.
2
Touch [Settings].
3
Touch [Audio].
4
Touch [Subwoofer].
5
Set each item as follows.
Frequency Low Pass Filter adjustment. /
[OFF]: Turns off the subwoofer
[80Hz], [120Hz],
output. (Default OFF)
[160Hz], [OFF]
Volume Adjusts the subwoofer level. 0 to 12
(Default 6)
[–], [+]
01_AMSTERDAM 290_1

Installation

Before Installation

Before installation of this unit, please note the
following precautions.
WARNINGS
• If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
• Do not cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
CAUTION
3
• Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as the
heat sink and enclosure become hot.
NOTE
• Mounting and wiring this product requires skills and
experience. For best safety, leave the mounting and
wiring work to professionals.
• Make sure to ground the unit to a negative 12V DC
power supply.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• If your car's ignition does not have an ACC position,
connect the ignition wires to a power source that
can be turned on and off with the ignition key. If you
connect the ignition wire to a power source with a
constant voltage supply, such as with battery wires,
the battery may be drained.
• If the console has a lid, make sure to install the unit so
that the front panel will not hit the lid when closing
and opening.
• If the fuse blows, first make sure the wires aren't
touching to cause a short circuit, then replace the old
fuse with one with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent a short circuit, do not
remove the caps on the ends of the unconnected
wires or the terminals.
• Secure the wires with cable clamps and wrap vinyl
tape around the wires that comes into contact with
metal parts to protect the wires and to prevent short
circuit.
• Connect the speaker wires correctly to the terminals
to which they correspond. The unit may be damaged
or fail to work if you share the
Radio mode
wires or ground
14
08.04.2019