Team Kalorik TKG AP 1000 Gebrauchsanleitung Seite 7

Fax +32 2 359 95 50

Fixing the lid
Hold the unit with one hand and turn the cover to the right until the cover is closed.
Installation of the filters
Remove the filter lid.
Remove the protective film from the HEPA filter and place it correctly in the unit.
Take out the filter
Filter replacement information
After about 1440 hours, when the filter needs to be replaced, the filter replacement indicator
will be flashing. After attaching the new filter, please press the power icon for 3 to 5 seconds.
Power supply
DC 5V
Power cord inlet
The device is powered by 5V DC - as it is in every standard USB socket.
The device comes with a cable to connect the power supply to the USB port.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Install HEPA + carbon filter
Power cord
7
Assembly page 7/59
TKG AP 1000 - 180821