Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Closing the zip fastener
1. Distribute the thermal insulation uniformly over the entire circumference of the tank [4].
2. Press both parts of the thermal insulation against each other and close the stitched in zip fastener from the top to the bottom [5],
[6].
3. Push the zip fastener fully down [7].
ATTENTION - material damage. Pliers or other tools could damage the zip fastener. Only close the zip fastener manually. Do not use
pliers or other tools. Ensure fleece is not trapped between the teeth of the zip fastening.
Note!
Press the thermal insulation uniformly against the tank from the middle outwards so that the insulation is more uniformly
distributed over the tank.
Note!
If the tank has pipe connections on both sides, position both halves of the thermal insulation and then close the zip
fasteners on both sides uniformly. In doing so, ensure that the thermal insulation is pressed against the tank dynamically
from the middle outwards.
Heat insulation PVC + fleece — 08. 2017
Closing the zip fastener
English — 3
Werbung
