Signal Connections; Control Personalities; Art-Net™ Connection - Chauvet Professional Ovation B-2805FC Schnellanleitung

AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Replacing The Fuse
1. Disconnect this product from power
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

Signal Connections

You can link the Ovation B-2805FC to a controller or controller software using a DMX connection or an Ethernet
connection. If using other Art-Net™ or sACN-compatible products with the Ovation B-2805FC , you can control each
individually on a single network. See the User Manual for information about how to connect and configure the product for
these signals.

Control Personalities

The Ovation B-2805FC uses DMX, Art-Net™, and sACN for its 33 control personalities, ranging from 3CH to 135CH in
1-cell modes and 7-cell modes:
Mode
DMX-VCW-CCT
HSV
RGB
RGBA
RGBAL
RGB EXT
RGBA EXT
RGBAL EXT
RGBAL Fine
RGBAL FULL
DMX Connection
The Ovation B-2805FC will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount of DMX512 data using an Neutrik®
etherCON® RJ45 connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com. Chauvet Professional recommends using unicast Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN compatible network. ACN is maintained by the
Professional Lighting and Sound Association (PLASA).
Master/Slave Connection
The Ovation B-2805FC uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Ovation B-2805FC supports RDM protocol that allows feedback to make changes to menu map
options. Download the User Manual from
Ovation B-2805FC QRG Rev. 10
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
1-Cell
3
3
3
4
5
8
9
10
10
17
www.chauvetprofessional.com
Wire (Europe)
Brown
Blue
Green/Yellow
2-Cell 5-Cell
N/A N/A
6 15
6 15
8 20
10 25
15 33
17 38
19 43
20 50
31 70
for more details.
EN
Screw Color
Yellow/Brass
Silver
Green
10-Cell
N/A
30
30
40
50
63
73
83
100
135
2