Charging The Battery - Party Light & Sound PARTY-210LED Bedienungsanleitung

EN
Only use the appliance in a moderate climate, not in tropical environments.
⠗
B atteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or
⠗
the like.
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
⠗
remain readily operable.

CHARGING THE BATTERY

Prior to using the system for the first time, please insert the supplied mains adaptor into the AC input on the
rear panel and plug the other end on a suitable wall outlet. Make sure that the "CHARGE INDICATOR" is ON 14
hours continuously.
NOTE: Please shut down the power switch after you have finished using the system.
IMPORTANT NOTE ON LEAD-ACID BATTERIES
1. PRIOR to using the unit for the first time, please charge fully the battery without any interruption.
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely! Once the battery is fully discharged, the current drain
for recharging will be so high that it will damage the charger and/or the power supply of the unit.
4. If you don't use the unit for a longer period of time, please CHARGE THE BATTERY COMPLETELY AT 100%
and check/charge it once per month otherwise the battery will be out of use.
The life time of the battery depends on the observance of these recommendations.
We cannot be held responsible for damaged batteries further to the non-observance of these basic rules.
DESCRIPTION OF THE REAR PANEL
1. Input selector: Press this button to switch between the various
inputs (AUX, USB, TF, Bluetooth)
2. Press to go back to the previous track.
3. Play/Pause
4. Press to go to the next track.
5. REC button: Press this button to record the sound of the wired mic
on the USB or TF.
6. Microphone Priority: Press this button to make sound priority for
microphone
7. USB stick input & Mini SD card input
8. Master volume control
9. Bass control
10. Treble control
11. Echo control for the microphone
12. Microphone volume control
13. Charging indicator
14. Microphone input
15. ON/OFF switch of the system
16. Switches the LED on the woofer on /off
17. Power cable input
18. DC 12V
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
1 2 3 4 5 6
15 16
POWER LED
AC INPUT DC 12V IN
18
17
100-240V~
50/60Hz
PARTY-210LED
SOUND SYSTEM 2 x 10"/25cm
Batt: Lead-acid/Plomb-acide 12V���� 5Ah
Consumption / Consommation: 30W
Max. power / Puissance max.: 600W
BT freq. band / Bande de fréq. BT: 2402-2480MHz
Max. RF emission power / Puissance d'émission HF max.: 1.35dBm
CAUTION - VORSICHT - ATTENTION - OPGELET
Shock hazard - Do not open the housing
Stromschlaggefahr - Nicht das Gehäuse öffnen
Risque de choc électrique - Ne pas ouvrir le boîtier
Risico voor elektrische schok - Niet de behuizing openen
Made in China for LOTRONIC S.A.- Av. Z. Gramme 9 - B-1480 Saintes
7
8
9
10
11
12
13
14
3