Overview Of The Components - Clatronic HL 3738 Bedienungsanleitung

• The fan heater should not be placed directly below a mains power
socket.

Overview of the Components

1 SPEED button
2 button (reduce temperature)
3 Display
4 button (increase temperature)
5 TIMER button
6 Contact surface
7 On- / off switch (I / O)
8 Air inlet
9 Wall spacer
10 Protective grille
11 Operation indicator lamp
Notes for Use
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding
and cardboard.
NOTE:
There might be dust and production residue present on
the appliance. We recommend cleaning the appliance as
described under "Cleaning".
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug to a properly installed isolated
ground socket.
CAUTION:
• This appliance is intended for use with a wall outlet
only.
• Make sure the wall spacers are resting against the
wall.
Turning the Appliance On / Off
• Set the switch to I position to power on the appliance.
The indicator lamp lights up.
• Set the switch to O position to power off the appliance.
The indicator lamp turns off.
SPEED Button
The button allows you to set one of two fan speeds:
- LL low
- HH high
32
HL3738_IM
TIMER Button
Use this button you can program an automatic switch-off
after 1 to 12 hours.
Safety Switch
Your heater is equipped with a safety switch that prevents
operation whenever the appliance is not being used in an
upright position. The safety switch prevents hazards caused
by overheating.
NOTE:
The appliance will switch on automatically once you use it
in a vertical position again.
Overheat Protection
The appliance features an overheat protection mechanism
causing the appliance to switch off automatically in case of
overheating.
• Let the appliance cool down for approx. 10 minutes
before using it again.
NOTE:
If the overheat protection mechanism causes the appli-
ance to switch off again after a short period, this might
indicate a defect.
1. Switch off the appliance and disconnect it from the
mains.
2. Have the appliance checked by your dealer or our
customer service.
Operation
By regularly switching the heater on and off the electronic
thermal fuse ensures that the desired temperature level
is maintained. To achieve the desired temperature level,
please proceed as follows:
NOTE:
The appliance starts at 25 °C once it has been switched
on.
1. Press the respective button to set the desired tempera-
ture. You may choose a setting between 15 - 32 °C.
2. Use the SPEED button to adjust the fan speed.
3. Once the desired temperature has been reached, the
heater and fan will switch on and off periodically.
During the heating pauses, the fan automatically
switches to the highest level HH (even if the lower level
has been set before) or turns off temporarily.
4. Once the ambient temperature drops, fan and heater
switch back on in order to maintain the desired temper-
ature level.
18.04.19