Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual
1. Before each use it's proper to test the function. When signs of wear or damage is a
use permitted under any circumstances.
2. Greased spindle before use.
3. Fix one double claw at the upper last possible end of the spring coil and the other
claw at the lower last possible end of the spring coil. Thus, the maximum tension
distance is reached.
4. Now you can move the compressor with the wrench tighten slightly until the claws be
on the spring coils and the spring tensioner not fall out, the assembly of the opposite
spring tensioner is facilitated.
5. Mount, exactly like first one, the second spring tensioner on the opposite side of the
spring (fig.2). Screw the two spring tensioner now mutual.
!Attention!
The jaws are not allowed to move laterally on the spring coils and
ou must be end the compression before touching the spring coils.
6. Compression the spring until the spring plate from the strut is free of tension.
7. After demounting, the spring must be relaxed.
Important
These notes are to be strictly observed. Only a long-term, trouble free and safe use of
this tool is to be expected.
• Before tensioning the spring, check whether the thread is free of dirt and lightly
greased.
• Do not cleaning with solvents!
www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
fig. 2
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
10255L
Werbung
