DGM ETV-2472WH Handbuch Seite 9

How to setup the TV
Use a supplied antenna cable to connect the VHF/UHF signal to the LED TV's ANT.
terminal
Connect the AC power cord at the back of the TV and connect the power cord to
wall outlet.
Insert the 2 batteries supplied in remote control.
Step1 Slide the back cover up to open the battery compartment of the remote control.
Step2 Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the
batteries with the (+) and ( - ) ends indicated in the battery compartment. Slide the
cover back into place.
EN6