Installation Of Five-Point Safety Seat Belt - Innovaciones M.S. SILLA DE AUTO TURN Bedienungsanleitung

8. Installation of five-point safety
seat belt
41
(Figure 8.1)
1. Insert the catch (19) into the snap pad (43). (Figure 8.1)
2. Turn the date sheet (40) under the catch (19) to the vertical, and insert
the sheet (40) into the hole (41) downward. (Figure 8.1)
3. Open the Velcro (39) on both sides to open the cloth cover, remove
the two retaining tabs and shoulder straps in the groove (39), and close the
Velcro. (Figure 8.2)
4. Snap the two tabs (44) and insert the catch (19). (Figure 8.3) Note: Make
sure that the seat belt is not distorted.
5. Pass the two shoulder straps (05) around the shoulder pad (06). (Figure 8.4)
6. Tighten the two straps of the shoulder strap (05) and the shoulder pad
(06) and pass through the hole (37), the shoulder strap and the shoulder
strap. (Figure 8.5)
37
06
05
(Figure 8.5)
31
32
60
19
38
39
43
40
(Figure 8.2)
Go to the back of the safety seat
7. Press down on the back cover button (31) to open
the seat back cover (32). (Figure 8.6)
8. Place the two shoulder rings (35) into the head at
both ends of the holder (36). (Figure 8.7)
9. Remove the three tabs (33) from the groove cove-
red by the instructions. (Figure 8.8)
10. and insert the two shoulder strap rings (42) into
the three tabs (33), respectively. (Figure 8.9)
Note: Make sure both straps and belts are not
twisted
35
11. Cover the back cover (32)
44
19
(Figure 8.3)
34
33
06
05
(Figure 8.4)
33
42