Valrom Industrie aquaPur AQUA00110000532 Gebrauchs- Und Montageanleitungen Seite 10

Mounting instructions
To install the filter on the cold water installation:
1. Shut off the water supply. Open a downstream consumer to release the pressure from the installation;
2. Connect the filter inlet to water supply using preferably a flexible hose with screwed union;
3. Secure the filter on the wall with matching screws (not included). A clearance of at least 50 mm must
be ensured in the lower part to allow the removal of the cup for cartridge replacement;
4. Connect the filter outlet to the consumer using preferably a flexible hose with screwed union;
5. Open the shutoff valve and make sure that the installation is leak proof;
6. Open the consumer and let the water flow for 2-3 minutes.
To change the filtering cartridge:
1. Shut off water supply from the stop valve;
2. Open the unit to release the pressure from the installation;
3. Turn off the unit;
4. Remove the cup of the filter you want to change;
5. Check whether the rubber O-ring is damaged;
6. Replace the filter;
7. Place the O-ring on the cup;
8. Screw the cup onto the cover;
9. Open the shutoff valve and make sure that the system is leak proof;
10. Open the unit to release the air from the installation.
11. Let the water flow for approximately 5 minutes.
10