Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Install a quick coupler suitable with the compressed air system in the workshop to the ball valve on the tank
FLUSH KIT.
2.
Unscrew the hex dip tube from the tank
3.
Fill the tank with a maximum of 750 ml (25.3 oz) of liquid.
4.
Screw the hex dip tube to the tank
5.
Close the ball valve of the tank
6.
Regulate the pressure of the Compressed air system of the workshop to a maximum of 7 bar (101.5 psi).
7.
Connect DPF FLUSH KIT to the Compressed air system in the workshop.
8.
Open progressively but slowly the ball valve of the tank
directions
1.
Place the vehicle on a lift bridge and jack it up.
2.
Wait the Exhaust System to be completely cold.
3.
Identify and remove the pressure sensor of the DPF.
4.
Consider the appropriate probe to use (hard
5.
Fill in the tank of DPF FLUSH KIT
outlet of vehicle exhaust fumes and wait 40min.
6.
Fill in the tank of DPF FLUSH KIT
outlet of vehicle exhaust fumes.
7.
Keep spraying air toward the outlet of vehicle exhaust fumes for at least 3 minutes.
8.
Install the pressure sensor of the DPF.
9.
Lower the lift bridge and push the vehicle outside the workshop.
10. Turn on vehicle's engine idling for approximately 20minutes and run the forced regeneration of the DPF
Ball Valve.
1
2
Hex Dip Tube.
3
Hard Probe.
4
Flexible Probe.
5
Flushing Gun.
6
Tank.
Art.-Nr. 007935019090
(en) PreParaTion For THe USe oF dPF FlUSH KiT
.
2
.
2
1
.
3
or fl exible
6
with fl ushing fl uid and spray the product (completely empty the tank) toward the
6
with Rinsing fl uid and spray the product (completely empty the tank) toward the
5
5
3
3
1
.
) and set it on the gun
4
2
2
of the DPF FLUSH KIT.
5
1
1
6
6
!
!
of DPF
1
4
4
Werbung
