Ups Setting - V7 UPS3000RM2U Bedienungsanleitung

2.4 LCD Display Wording Index
Abbreviation
ENA
DIS
ESC
ON
OK
EP
AO
AC
TP
CH
SF
EE
BR

2.5 UPS Setting

Parameter 1
Interface
01 Output Voltage Setting
02 Programmable outlets enable/disable
03 Programmable outlet settings
Display Content
Parameter 2
Setting
For EU Models you may choose 208/220/230/240 VAC settings
230VAC is the default. (Changing this setting is not recommended)
For US Models you may choose 110/115/120/127 VAC
120VAC is the default. (Changing this setting is not recommended)
ENA > Programmable outlets enabled
DIS > Programmable outlets disabled
Set up the backup time limits in minutes from 0-999 for programmable out-
lets which connect to non-critical devices on battery mode. (Default = 999)
Definition
Enable
Disable
Escape
ON
OK
EPO
Active Open
Active Close
Temperature
Charger
Site Fault
EEPROM Error
Battery Replacement
There are 2 parameters to set up the UPS
1. For program alternatives (Refer to table below)
2. Setting options or values for each program