Turning The Unit Off (Putting It In Standby); Inserting Sd Cards; Camera Connection And Attachment; Connecting External Mics And Monitoring Equipment - Tascam DR-70D Bedienungsanleitung

Turning the unit off (putting it in
standby)
When on, slide the HOLD/
switch toward
until appears on the
LINEAR PCM RECORDER
display.
The unit turns off (enters standby) after it completes
its shutdown process.

Inserting SD cards

Open the front cover on the front of the unit.
1.
Insert an SD Card into the slot as shown in the
2.
illustration until it clicks into place.
Camera connection and
attachment
In order to output the sound from this unit to a DSLR
camera and monitor sound from the camera with
this unit, you must connect them with commercial-
ly-available 3.5mm stereo mini plug cables.
If you want to record audio from this unit with a
1.
OUT jack on the right
camera, connect the
side of this unit with the external mic input on
the camera.
If you want to input audio from the camera and
monitor it with this unit, connect the
jack on the right side of this unit with the audio
output jack on the camera.
External mic input jack
Audio output jack
NOTE
Refer to the camera's operation manual to
identify connectors on the camera.
Use the item on the
2.
OUTPUT LEVEL
screen to adjust the volume output
SETTING
to the camera.
To mount the camera on this unit, use the
3.
camera attachment screw on the top of the
unit.
Connecting external mics and
monitoring equipment
Connect an external stereo mic to the EXT IN 1/2
jack on the right side of the unit.
To listen with headphones, connect them to the
PHONES jack.
To listen with an external monitoring system
(powered monitor speakers or an amplifier and
speakers), connect it to the
External mic
IN
DSLR camera
Powered monitor
speakers or amplifier
and speakers
MONITOR
OUT/LINE OUT jack.
Headphones
11
TASCAM DR-70D