Safety Standards - RIGO MRI Gebrauchs- Und Wartungshandbuch

7 USABLE COVERING MATERIAL (Indicative table)
MRI and MRI-AS models: SUITABLE FOR LIGHT AND NOT TOO VISCOUS MATERIALS (VARNISHES)
WATER OR SOLVENT VARNISh
Zinc rust preventers
Grey rust preventers
Red rust preventers
EN
Stains
Flatting
Micaceous (metal enamel)
Enamels
Polyurethane enamels
MRI and MBA models: SUITABLE FOR HEAVY AND THICK MATERIALS (PAINTS)
WALL PAINTS
Hydro-paints
Multicolours
Fine quartz paints
Temperas
applicable only by means of spraygun type MBL
PLASTIC COVERINGS
Materials with granulometry of maximum 3 mm
Bituminous coating
Follow the manufacturer's instructions concerning the covering products in order to obtain products with good characteristics
of mechanical and atmospheric resistance. Therefore prepare the products following the manufacturer's instructions.
8 INCORRECT AND DANGEROUS USES
Using the unit in a different way than indicated by the manufacturer could damage the
equipment and endanger the operator. The unit is not designed to use dangerous,
explosive and/or toxic materials and herbicides.
Our company is not responsible for accidents deriving from the use of the machine by NOT TRAINED and not qualified
personnel, for aims different from the ones indicated above.

9 SAFETY STANDARDS

Warning! Observe the following safety standards:
Consider the use environment:
- The airbrush is used with painting or solvent products which are highly inflammable;
- Provide for good lighting;
- Do not work in stuffy rooms with no adequate air change.
Remarks on chemical products:
- DO NOT USE with foodstuffs or medicines;
- Never point the airbrush to human body or animals.
Keep the tools in a safe place:
- The tools which are not used must be placed in a dry and safe place;
- The tools must only be used by trained personnel and must be kept out of the reach of children.
Keep the tools with care:
- Keep the tools clean and always efficient observing the use and maintenance instructions.
Nozzle diameter
0,5 0,7 1 1,3
✔
✔
✔
✔ ✔
✔
✔
✔ ✔ ✔
✔
Nozzle diameter
0,5 0,7 1 1,3
Nozzle diameter
0,5 0,7 1 1,3
- 8 -
1,7 2,1 2,5 3
✔
✔
✔
✔
1,7 2,1 2,5 3
✔ ✔
✔ ✔
✔ ✔ ✔
✔ ✔
1,7 2,1 2,5 3
✔
✔ ✔
3,5
3,5
3,5
✔