Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The lighter can be used to light cigarettes,
candles, and dry and � ammable materials.
Do not use to ignite liquids, as rapid ignition
and heat can aff ect the poles and the
material around them.
Make sure that the poles do not get dirty
from candle wax or ash. If they are dirty,
clean them carefully with a cotton swab to
ensure optimal function.
Charging
1. Connect the USB cable supplied to a
charger, a computer or other equipment
with a USB connector. The maximum
voltage must not exceed 5 V +/- 0.5 V and
an output current of less than 3000 mA.
2. When charging is in progress, an LED
light comes on to indicate charging. If the
lighter has not been used for a prolonged
period, it may be necessary to connect
and disconnect it a few times.
3. Once charging is complete, the LED light
goes out. Disconnect the product to
stop charging to ensure that it does not
overheat. Overcharging may also reduce
the battery life and performance.
Charging takes around 1-2 hours +/-
depending on the voltage and current.
Lithium-ion batteries can be recharged
several hundred times during their life.
Immediate and frequent charging after use
prolongs the battery life.
The product has several safety features
including protection against overcharging, so
it does not become overloaded. The product
will also switch off if it is used continuously
for longer than it is designed for. Put the
product to one side for an hour or so. It can
then be used again.
Storage and cleaning
Make sure that the poles do not get dirty
from candle wax or ash. If they are dirty,
clean them carefully with a cotton swab to
ensure optimal function.
Wipe the lighter with a dry cloth. Store in a
dry location in the case provided.
EC Declaration of Conformity
Manufacturer: Schou Company A/S,
Nordager 31, 6000 Kolding, Denmark hereby
declares that
ELECTRONIC LIGHTER
67711
has been manufactured in accordance with
the following standards:
EN 55014-1:2006+A1+A2
EN 55014-2:2015
EN 62321-1:2013
in accordance with the provisions of the
following directives:
2014/30/EU
The EMC Directive
Kirsten Vibeke Jensen
Product Safety Manager
16.01.2019 - Schou Company A/S, DK-6000 Kolding,
Denmark
Manufactured in P.R.C.
© 2019 Schou Company A/S
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.
GB
11
Werbung
Inhaltsverzeichnis
