Establishing The Wi-Fi Connection Via Wps; Establishing The Wi-Fi Connection Via The "Undok" App - Silvercrest 116073 Bedienungsanleitung

SilverCrest SMRA 5.0 A1

Establishing the Wi-Fi connection via WPS

If your router features a WPS button, the easiest way to connect the adapter (A) to the network is using this button.

Place the power switch (12) in "ON" position and press the On/Standby button (3) to go to connection mode.
The blue LED flashes slowly.

Next press the WPS button on your router and confirm the connection by pressing the WPS button (5) on the
adapter (A) front panel.
See the operating instructions for your router.
The adapter (A) establishes a network connection. The blue LED flashes 3 times fast, followed by a short pause.

After the connection has been established, the blue LED goes on.

Now the adapter (A) can play audio signals from the network.

The adapter (A) will save the connection data, so the next time you switch it on you don't need to re-establish
the connection again.

Establishing the Wi-Fi connection via the "UNDOK" app

If you cannot establish the connection using WPS, you can use the "UNDOK" app to connect the adapter to the
network.

Power on the adapter and start the AP mode.
When using it for the first time, the adapter starts the AP mode automatically.
Otherwise hold the RESET button (10) for approx. 5 seconds to restart the adapter.
After a few seconds, the blue LED flashes slowly. The adapter is now in AP mode.

Launch the UNDOK App. Tap on the menu in the upper right corner and select the "Set up new audio system"
option to continue.
14 - English