Seav WiSun S/F 433 Installationsanleitung Seite 7

WiSun Wireless Sensor S/F
GB
Wind, Sun Wireless Sensor to be coupled with SEAV electronic control units
for the automation of rolling window shutters and sun blinds.
- Mod. WiSun S/F 433 : 433,92 MHz
important for the user
- The device must never be used by chil-
dren or persons with reduced physical-
psychological abilities, unless supervised
or trained on the functioning and the use
modalities.
- Do not allow children to play with the
device.
- ATTENTION: keep this instruction manual
and respect the important safety pre-
scriptions contained herein. The non com-
pliance with the prescriptions may cause
damages and serious accidents.
- Frequently examine the plant to detect any
signs of damaging. Do not use the device
if a repair intervention is necessary.
:
a : All operations which require the
ttention
opening of the casing (cables connection,
programming, etc.) must be carried out by
expert personnel during installation. For
any further operation which requires the
casing to be re-opened (re-programming,
repair or installation amendments) contact
the after-sales assistance.
i
mportant for the installer
The device must be permanently con-
-
nected to the power supply network and
not have any type of sectioning device of
the 230Vac electric line, it will therefore
be under the care of the installer, to pro-
vide the plant with a sectioning device.
It is necessary to install a single-phase
switch with over-voltage category III. It
must be positioned so as to be protected
against accidental closures.
7