Basic Use Of Your Dvd Player; Introduction; Front-Panel Controls; Basic Operation - Arcam DV135 Handbuch

Basic use of your DVD player

Introduction

'Basic use' explains how to play a DVD, CD or other type of disc. Note that it may be necessary to
configure your player correctly for your system before optimum – or any – playback can be achieved.
Player configuration is described beginning on page 10.
More sophisticated features – such as special playback modes and programming jumps and playback
sequences – are described in the 'Advanced features' section, later in this handbook.

Front-panel controls

Switching on
Switch the unit on by pressing the
up and red when in stand-by mode (stand-by is operated from the remote control).
Note that the remote control sensor is located on the right-hand side of the display window. Do not
obstruct this or the remote control will not work.

Basic operation

Loading a disc
Press
LOAD
back side facing down (some discs are double sided, in which case the side labelled 'side A' should face
up to play side A).
Press
LOAD
Playing a disc
Many DVDs begin playing automatically, but some titles begin by displaying a menu. Select the menu
item 'Play movie' (or similar) using the cursor pad, then press
For discs that do not play automatically (including CDs and VCDs), press
Fast play
8
Press
speeds for fast playback are available: x2, x4, x8, x16, x50 and x100 (depending on disc type). Press
the button repeatedly to cycle through the different speeds. To resume normal playback speed, press
.
PLAY
Fast playback is not available for MP3/WMA discs.
Skipping chapters/tracks
To skip chapters (or tracks on a CD), press
When skipping back, the first button press takes you to the beginning of the current chapter. Pressing
the button again takes you to the start of the previous chapter.
Pausing playback
Press
PAUSE
on the front panel or
PLAY
Stopping playback
Press the
When playing a DVD, pressing
resumes from the point it was stopped.
If you press
Front panel menu navigation
If desired, it is possible to navigate disc and player menus using the front panel buttons; to this end, the
button is provided.
NAV
Pressing the
the front panel display. In this mode, the front panel buttons take on the functions illustrated above each
button, for example the
To exit navigator mode, press the
POWER
on the front panel (or on the handset) and place the disc on the tray, with the play-
OPEN
on the front panel to close the tray. The disc loads after a pause of a few seconds.
7
or on the front-panel or remote control to play fast forwards or backwards. The following
;
on the front panel or on the remote control to pause playback. To resume playback, press
4
on the handset.
button on the front panel or
STOP
once performs a 'resume stop'. If you now press
STOP
twice, this is a 'complete stop', and playback resumes from the beginning of the disc.
STOP
button causes the player to enter 'navigator' mode, indicated by 'NAV' being shown on
NAV
and buttons become
STOP PAUSE
button for a second time.
NAV
����� ��
���� ���� ���� �����
button. The status LED glows green when the unit is powered
to start playback.
OK
PLAY
/ 0
or .
<
on the remote control to stop playback.
6 5
and .
����� ����
�����
���
.
, playback
PLAY
����������������
�����
DV135
E-7