Operation - Walmag BUX NEO 150 Bedienungsanleitung

EN

OPERATION

INSPECTION AND MAINTENANCE OF THE LIFTING MAGNET
1. Check the condition of the
magnet each time before
use. Wipe the pole shoes on
the magnet and the contact
surface of the workpiece
burrs or irregularities.
3. Grasp the handle and switch the
magnet on by placing the handle
A
in position . Allow the spring
pressure to pull the handle back
into the locked position. Check
this! Only now the handle can be
released.
Never try to switch the magnet ON or OFF while
it is sitting on very thin or on non-magnetic
material or in the air.
5 Guide the load by holding
the corners. Avoid collisions,
swinging and shocks. Never
stand under the load and keep
the load horizontal!
2. Place the magnet on the
workpiece and position
magnet in such a manner that it
remains horizontal during lifting
(determine the centre of gravity
of the workpiece as accurately as
possible).
4 Lift the load
centimetres and give the load
is well gripped. Never stand
under the load!
6. Grasp the handle bal and
pull the handle out of its
locked position. Switch the
magnet off by placing the
handle in position B. Allow
the spring pressure to pull the
handle back into the locked
position. Check this! Only now
the handle can be released.
Caution: light workpieces may stick to the
magnet after it has been switched off!
Never release the handle before same is fully
locked.
the
INSPECTION AND MAINTENANCE OF THE LIFTING
MAGNET
Before use:
Check the entire magnet visually. Brush the pole shoes of
the magnet and the contact surface of the workpiece clean.
the magnet if you have discovered any defects. Check the
operation of the handle and locking plate.
Weekly:
Check the entire magnet, including the hook eye, lifting
cover and bolts for deformities, cracks or other defects.
If the lifting eye is deformed or more than 10% worn off,
it should be replaced. Check the presence and legibility of
the type plate and instruction plate. Check the pole shoes.
If they are more than 10% damaged (pits, burrs etc.) the
magnet should be returned to your supplier or an authorised
agent for regrinding. Lifting capacity is checked following this
operation.
several
Annually:
Have the lifting capacity of your magnet checked by your
supplier or an authorised agent at least once a year.
3