Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning your ice maker befroe first using
1. Open the door.
2. Clean with diluted detergent, warm water and a
soft cloth.
3. Repeatedly clean the water contacting inner
parts, you can pull the Water drain pipe of the
water tank indicating "H" in above illustration to
drain the cleaned water in the water tank, next
clean the inner ice-storing cabinet. After that
drain out all of the cleaning water from the water
drain port located at the back of the unit ("7"in
Water connection for your ice maker
Important: Be sure to use the new hose-sets sup-
plied with the appliance.
Connect the water supplying hose to the unit
Step 1: First remove the clipper on the water inlet
port (indicated in the following illustration
"B") located at the back of the unit. Remove
the anti-dust plug.
Connecting the water drain pipe
Pull out the water drainage cap with black color (in-
dicated "A" in above illustration), then connect the
white drainage pipe included in accessory, connect
Connect the water hose to the water faucet of the water main supply system
The supplied water quick-connector must be
screwed to a faucet; remove the clipper from the
water quick-connector, insert the other end of the
water hose into this quick-connector port complete-
Step 1: Qucik-connector and the
water faucet
Step 1: Remove the
anti-dusty plug
Water inlet port on the
unit back
Press inward the active
out circle, then remove
the anti-dusty plug.
Step 2: Screw the qucik-con-
nector on the water faucrt by
the screw thread, and remove
the clipper
Remove the
clipper first
above illustration). Reinstall the water drain pipe
and the cap of the water drain port, otherwise, the
unit will not work properly. Discard the first ice-
cube after cleaning.
4. The outside of the ice maker should be cleaned
regularly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a clean soft
cloth.
Step 2: Insert the one end of the white water hose
into the water inlet port, and push inward
completely, and install back the clipper, then
water hose connection is completed.
Step 2: Insert the water
hose
Then install back the
clippe
Remove the
Remove the
clipper first
clipper first
First insert the
water hose inward
completely
the other end of this drainage to the main water
drainage pipeline.
ly, install back the clipper.
Important: The water pressure of main water supply
system must be 0.04-05 MPa at
Step 3: Insert the water hose
completely
Push inwards
White water hose
(accessory)
Step 4: Insert back the clipper
EN
NL
9
9
Werbung
Inhaltsverzeichnis
