CARDIN ELETTRONIC SSB Serie Bedienungsanleitung Seite 22

Note: You cannot memorise a keyboard that already exists in the receiver's memory: in this case, while you
are memorising the channel (point 3) the red LED on the receiver will stop flashing.
The programming procedure will only carry on after the MEMO button (in receiver) has been released.
If you don't press the channel a second time within 15 seconds the memorisation procedure will quit without
memorising the keyboard.
Procedure 2: memorisation "via radio" with the help of a standard transmitter
1) Make sure the "MEMO-RADIO" button has been inserted in the receiver
2) Type a user code into the keyboard:
the keyboard is ready to transmit (green LED lit)
3) Using a transmitter in which at least one channel button "A-B-C-D" has already
been memorised, press the "MR" button as shown in the drawing.
Note: All receivers within range when the channel button is pressed (and which
have at least one of the channel buttons memorised) will activate their signal buzzer.
4) Press one of the channel buttons on the transmitter.
The receivers which do not contain the code will sound a 5-second long beep and
then deactivate. The receiver that contains the code will sound a 1-second long beep
and enter the "remote" programming mode.
All rights reserved. Unauthorised copying or use of the information contained in this document is p
Drawing number :
Product Code :
Draft :
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/4
22
ON
Description : MEMORIZZAZIONE CODICE TX-RX
DM0531
RCQ449100
P.J.Heath Date : 13-04-2001
A
3