Remote Control; Inserting Batteries Into The Remote Control - Arcam D33 Handbuch

remote
control
The D33 is supplied with the CR107 remote control.
Using the remote control
Please keep in mind the following when using the

remote control:

Ensure there are no obstacles between the
<
remote control and the remote sensor on the
front panel. The remote has a range of about 5
metres. (If the remote sensor is obscured, the
IR in remote control input jack on the rear
panel is available. Please consult your dealer
for further information.)
Remote operation may become unreliable if
<
strong sunlight or fluorescent light is shining
on the remote sensor of the unit.
Replace the batteries when you notice a
<
reduction in the operating range of the
remote control.
Inserting batteries into the
remote control
1. Open the battery compartment by sliding
open the battery cover.
2. Insert two ' A AA' batteries into the battery
compartment – facing opposite directions, as
in the diagram and the battery compartment
indication.
3. Slide the battery cover back into place.
Notes on batteries:
Incorrect use of batteries can result in hazards
<
such as leakage and bursting.
Do not mix old and new batteries together.
<
Do not use non-identical batteries together –
<
although they may look similar, different batteries
may have different voltages.
Ensure the plus (+) and minus (-) ends of each
<
battery match the indications in the battery
compartment.
Remove batteries from equipment that is not
<
going to be used for a month or more.
When disposing of used batteries, please comply
<
with governmental or local regulations that apply
in your country or area.
E-9
Alternative code selection
In the rare situation that the CR107 remote control
happens to operate another device in the room, the
IR code can be changed to an alternative RC5 system
number.
To change the remote control to the alternate code:
1. Press and hold the and keys for 6 seconds until
0 /
the LED at the top of the remote remains lit.
2. Press to select the alternative IR codes (RC5
OPT2
system code 28) or press to select the
OPT1
original code set (RC5 system code 27).
If no key is pressed within 10 seconds the remote will
return to normal operation.
Note: the selection of the alternate codes is reset when
batteries are changed.
In addition to changing the remote handset, the D33
unit must also be reconfigured to respond to the
alternate codes. With the unit powered on, press the
and buttons simultaneously. The
OPTICAL 1 AES/EBU
LED will flash to indicate remote code selection.
FILTER
Press the button to toggle between the normal IR
FILTER
codes ( LED flashing) and the alternative codes
FILTER 1
( LED flashing). Press any other key to exit the
FILTER 2
code selection mode.