D - Assembling The Pad Holder; E - Assembling The Tank (Optional); F - Electrical Connection - Wirbel C 143 L08 Gebrauch Und Wartung

2.1.d - Assembling the pad holder

(Figs. 3-4)
- Tilt the machine, pivoting, with the handle
straight, with your feet on the wheels and
place it on the handle.
- Place the pad holder (8) on the pad (9)
being careful to centre it properly to avoid
unbalancing the rotation.
- Place the pad holder (8) complete with
pad, on the base of the machine, fitting
the appropriate butterfly coupling, as
described in the "Assembling the brush"
paragraph.
To disassemble the pad holder, tilt the ma-
chine and turn it in the opposite direction to
that shown by the arrow (A).
WARNING:
Use only the pads provided by the manu-
facturer for the machine model as indi-
cated in the PERMITTED ACCESSORIES
table in this manual.
Using other types of pads can compro-
mise the safety of the machine.
2.1.e - Assembling the tank
(optional) (Figs. 5/11)
- Loosen the two screws (10) of the upper
support (11) of the handle (Fig. 5).
-
Make sure that the lower support (12)
rests on the plate located on the handle
rod (Fig. 8).
- Screw the chain (13) onto the top of the
tank (14) (Fig. 6).
- Connect the tube (15) into the fitting (16)
at the bottom of the tank (14) (Fig. 7).
- Place the tank (14) on the lower support
(12), taking care to align the coupling tab
(17) with its slot (18) (Fig. 8).
- Lower the upper coupling (11) and attach
it to the coupling tab (19) on the top of the
tank (14) (Fig. 9).
- Tighten the two screws (10) of the upper
support (11) of the handle (Fig. 9).
- Connect the tube (20) fitting (21) to the
hole on the machine body (Fig. 10).
- Attach the chain (22) to the hook (23) on
the handle (Fig. 11).

2.1.f - Electrical connection

- Connect the machine power cable to a
mains socket with characteristics cor-
responding to those shown on the ma-
chine's technical data plate.
WARNING:
- Make sure the mains electrical system
has a circuit breaker and is earthed.
- Unwind the power cable completely be-
fore operating the appliance.
- Use an extension cord only if in perfect
condition and make sure the cross sec-
tion is appropriate for the power of the
appliance.
- Never allow the power cable to slide
over sharp edges and do not crush it.
- The socket should be easily accessible.
- Make sure the power cable is not dam-
aged.
ENGLISH - 4
www.ghibliwirbel.com www.ghibliwirbel.com
Professional Cleaning Machines Since 1968 Professional Cleaning Machines Since 1968