Specifications - SW Stahl PROFI Tools 20731L Bedienungsanleitung

20731L / 20741L

Specifications

max. 560 mm
min. 95 mm
Operations
The owner and/or operator is responsible for providing maintenance, maintaining all decals or warning
labels and while in use, maintaining the unit in good work order. If the owner and/or operator is not
fluent in English, the product warnings and instructions shall be read and discussed with the operator in
the operatorʼs native language by the purchaser/owner or his designee. The jack shall be inspected per
the instruction manual prior to use.
It is the owner and/or operators responsibility to study all WARNINGS on the product label and the
operating and maintenance instructions prior to operation of this unit. The owner/operator shall retain
the product instructions for future reference.
Raising the vehicle:
1. Make sure the jack and vehicle are on a hand level surface.
2. Always set the vehicle parking brake and block the wheels.
3. Consult the vehicle ownerʼs manual to ascertain the location of jack points and position the jack
beneath the prescribed lift point.
4. Turn the release valve clockwise to the closed position. DO NOT OVERTIGHTEN!
5. To raise the vehicle to the required height, place the handle into the socket and pump up and down.
6. Place jack stands beneath the vehicle at locations recommended by the vehicle manufacturer. Do
not get under the vehicle without jack stands. Jacks are not designed to maintain heavy loads for
long periods of time.
7. Turn release valve SLOWLY counterclockwise to lower the vehicle onto the ground.
Lowering the vehicle:
1. Turn the release valve clockwise to the closed position.
2. Pump the handle to lift vehicle off of jack stands.
3. Remove the jack stands. Do not get under or let anyone else under the vehicle while lowering.
4. Turn the release valve SLOWLY counterclockwise to lower the vehicle onto the ground.
Inspection
The product shall be maintained in accordance with the product instructions. No alterations shall be
made to this product.
1. Before use, a visual inspection of the jack should be made for abnormal conditions such as cracked
welds, damage, bent, worn, loose or missing parts or hydraulic leaks.
2. Inspections shall be performed in accordance with this manual.
3. The product shall be inspected immediately if the jack is believed to have been subject to an
abnormal load or shock. It is recommended that this inspection is made by an authroized customer
service representative prior to use.
SW-Stahl GmbH
www.swstahl.de
An der Hasenjagd 3
D-42897 Remscheid
ENGLISH
ENGLISH
SPECIFICATIONS
465 mm
OPERATIONS
INSPECTION
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
47 kg
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
3 T
www.swstahl.de
5