Velleman components KNS3 Bedienungsanleitung

1. Introduction & Characteristics
Thank you for buying the KNS3 ! Read this manual carefully before bringing the device into use.
• Familiarise yourself with the operation of transmissions steered through gears or pulleys.
• Easy to build, no glue or soldering required.
• Dislodge the pre-cut pieces when you need them and not before. Sand the jagged edges before use (sandpaper
included)
• The kit is powered by 2 AA-batteries (not included).
The kits of the KNS-series are supplied with prepunched boards, a gearbox, gears, shafts, a switch, a motor, a
battery holder and all necessary parts.
Note that the figures with the assembly instructions can be found in the second folder "KNS3 – Figures"!!!
2. Parts List
Part n° Quant.
1 1
2 1
3 1
4 2
5 1
6 1
7 1
8 1
9 1
10 1
11 1
12 1
13 1
14 1
3. Prepunched Boards (see "KNS3 – Figures
4. Assembly (see also "KNS3 – Figures
Fig. 3 : The gears (n°9/10/11/12) should be placed to the left of the pinion gear (n°8). Put one N-shaped nylon
connector (n°16) downward and another one upward. Note that the protruding edge should point towards
the metal case.
Fig. 4 : Screw n°15 to boards n°2 & 3 and fix them to board n°1.
Fig. 5 : Do not turn screws 22 & 23 too tightly if you want the Robomech to walk smoothly.
Fig. 6 : Screw battery holder n°3 to the back of board n°1.
Fig. 7 : Figure 7 in KNS3 – Figures shows how the head should be assembled
Fig. 8 : Connect the head to the board and consult the wiring diagram in fig. 9.
Fig. 9 : Insert one wire in the PVC tube (n°26), twist the two wires and cover the joint with the PVC tube.
KNS3
KNS3 – ROBOMECH
Description
gearbox
motor 3Vdc
battery holder
metal foot
slide switch with wire
metal shaft (2 x 40mm)
metal shaft (3 x 52mm)
pinion gear 8T
face gear 36T/10T (white)
gear 40T/10T (white)
gear 40T/10T (red)
gear 40T/10T (green)
wire with terminal (yellow)
wire with terminal (green)
)
"
Part n° Quant.
15 2
16 2
17 2
18 4
19 2
20 4
21 16
22 2
23 2
24 6
25 2
26 1
27 2
28 8
)
"
1
Description
fixing plate (L-shaped)
nylon connector (N-shaped)
nylon pad
nylon post (H : 3mm)
LED with wires
nut M3
self-tapping screw (2 x 4mm)
screw (3 x 14mm)
screw (3 x 16mm)
washer
self-tapping screw (3 x 16mm)
PVC tube (1.5 x 15mm)
PVC tube (2.4 x 15mm)
nylon pad Ø8mm
VELLEMAN