About This Document; General Safety Instructions - Franklin Electric 2803552115 Installations- Und Bedienanleitung

1. About this document

• The instructions and information in this manual
form an integral part of the equipment and descri-
be its safe and intended use.
• Keep this manual in the immediate vicinity of the
installation.
• Hand this manual to any subsequent owner or
installer.
•
the equipment described in this manual.
• Technical changes may be made without notice in
the interest of product development.
2. Warnings notices and symbols
Warning notices
and symbols
Danger!
Warning!
Important information. You
should observe this informati-
on to ensure correct and save
operation. Possible danger of
physical harm and/or material
Information!
damage may otherwise result.
3. Safety
Observe the safety rules in this manual. Safety
measures are listed in this section.
Intended use
• The equipment described in this manual is inten-
ded for use with a Franklin Electric submersible
motor.
•
• Pump and motor must operate under water only.
•
directives, regulations and statutory provisions
Loss of guarantee and liability exclusion
Franklin Electric shall not be liable for the damage
resulting from any non-intended use. The risk of such
use rests solely with the user.
Target group
Any electrical system such as described in this
3
Meaning
Direct/Immediate danger to
life and/or health
Possible danger to life and/or
health.

General safety instructions

The following safety instructions must be observed
prior to putting the control gear into use:
• Mount the control gear in an appropriate location,
orientation and position.
• Do not modify the control gear or its electrical or
mechanical connections.
• Do not remove any part or parts of the control
gear.
• Never install any control gear with a known defec-
tive motor.
• Remove power before working on control gear.
• Make sure that nobody can switch on power unex-
pectedly while work is being carried out.
• Never work on electrical systems during a thun-
derstorm.
• Commissioning or testing can only be performed
technician).
• Replace all protection and safety devices after
completing work.
• Ensure that all electrical connections and safety
devices have been checked and that all fuses
and safety devices have been set correctly before
switching on.
• Make sure that no danger zones are accessible
(e.g. electrical connections).
• Read the pump manufacturer's commissioning
instructions before switching on any control gear.
• Repairs must only be carried out by authorized
professional workshops. Use original Franklin
Electric spare parts only.
4. Storage, transport and disposal
Storage
• Do not remove the control gear from its original
packaging until the time of installation.
• Keep this manual with the control gear for future
use.
• Do not store in direct sunlight or close to any heat
source.
Transport
during periods of transport.
(-10°C to +55°C non-condensing).
Unpacking
After unpacking, check for physical damage that
may impact on the safety of the control gear such as
a damaged enclosure, dislodged cable glands etc.
Observe the local regulations and dispose of any
packaging material accordingly.
GB