Velleman AVMOD18 Bedienungsanleitung Seite 6

•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects
or problems
4. Features
• wireless transmission of A/V signals through walls and between rooms
• uses 5.8GHz frequency which gives less interference with other wireless
products than the 2.4GHz frequency
• 3 video inputs; connect 2 A/V transmitting devices simultaneously.
• comes with: 2 x SCART to RCA A/V cable, 1x SCART to 3.5mm jack, IR
extender cable and 2 power adapters
• optional video cables: AVB020/2.0, AVB020/5.0, AVW084, AVW084G, AVW085,
AVW085
5. Overview
Refer to the illustrations on page 2 of this manual.
A 5.8 GHz antenna (folded upwards)
B channel selector switch
C channel indicator
D stand
E A/V input (transmitter only)
F infrared remote output (transmitter only)
G S-video connector
H RCA video connector (yellow)
I RCA audio connector R (red)
J RCA audio connector L (white)
K power connector (9VDC/300mA)
L ON/OFF switch
see explanation above
6. Installation
Refer to the illustrations on pages 2, 3 and 4 of this manual. Make sure all devices
are disconnected from the mains before making any connections.
Transmitter [5]
•
The transmitter can be recognized easily as it has an A/V input port at the front
[E] and an IR output port [F] at the back.
•
Use the SCART-to-RCA A/V cable marked with TRANSMITTER (included) or
use an appropriate S-video cable (1, not included).
Note: when using an S-video cable, the RCA connectors are disabled. Always
use an S-video cable on both transmitter and receiver.
19.02.2010
AVMOD18
1 - front view
2 - rear view
3 – top view
4 – side view
6
©Velleman nv