Cleaning And Care - Vitek VT-2212 G Die Betriebsanweisung

T-2212_IM_70x130.indd 6
ENGLISH
«R2» – high speed, attachment rotates to the right, the
illumination (12) lights brighter;
«L1» – low speed, attachment rotates to the left, the
illumination (12) lights up;
«L2» – high speed, attachment rotates to the left, the
illumination (12) lights brighter;
– Carefully move the attachment along the surface being
treated.
– After you finish using the unit, set the switch (9) to the
position «0», the illumination (12) will go out.
– Remove the attachment (2-7) from the motor unit (8).
Tips
Follow these recommendations to keep your nails healthy
and achieve good results when using the manicure set.
• Avoid getting of irritant chemicals on your nails.
• Do not expose your hands to extreme cold. Always wear
gloves when it's cold.
• Do not use alkaline soap and excessive amount of water
when washing your hands.
• Good nail hydration is a key to healthy and strong nails,
resistant to nail peeling and fragility.
• Polish your nails before using a moisturizer.
• After a manicure procedure treat your nails with moistur-
izing cream or lotion.
• Use only high quality nail polish to prevent nail peeling.
• Before removing cuticles moisturize them first and then
lift gently.
• For safe removing of cuticles , use manicure clippers
instead of scissors.
• To prevent nail thinning, smoothen and polish your nails
with 7-10 days intervals.

CLEANING AND CARE

– Before cleaning set the operation mode switch (9) to
the position "0", remove the attachments (2-7) from the
motor unit (8), if they are installed, and remove the bat-
teries from the battery compartment (14).
– Clean the body (1) and the motor unit (8) with a soft,
slightly damp cloth, and then wipe them dry.
– Do not use abrasives and solvents to clean the unit.
6
25.10.2017 18:38:17