Iomega ditto Installation Seite 6

Preparing the Computer Preparing the Computer Preparing the Computer
Preparing the Computer Preparing the Computer
1 Remove any CD-ROM disks or floppy disks from the
computer's drives, turn off the power switch, and
disconnect the power cord.
WARNING: Always disconnect computer electrical power at the power source before
beginning any computer hardware change.
2 Remove the computer cover.
(Most computers have three or four screws on the rear panel that hold the cover. Refer
to your computer manual if removal is unclear.)
Disconnect power
3 Locate a vacant 5
cover and, if necessary, the metal shield.
5 1 /4-inch Bay
Metal Shield
Plastic Cover
6
1
/ -inch drive bay. Remove the plastic
4
5 1 /4-inch Bay
Metal
Shield
Plastic
Cover
Tower View