Adjust Rh Hysteresis; Adjust Rh Night & Night Delay; Rh Min/Max; Co Level - TechGrow Humi Dual Pro Handbuch

8.3 Adjust RH hysteresis

Select "RH +/-" and press the PTK.
RH set 56 %
=> RH +/- 8 %
>> NEXT >>
Adjust the hysteresis by turning the PTK.
Press the PTK to confirm.
Select >> NEXT >> and press the PTK to proceed with
adjusting night mode settings.
8.4 Adjust RH night & night delay
The Humi Dual Pro allows you to set a different setpoint
for night mode. Moreover, it offers night delay to slow
down switching between day and night mode.
Select >> NEXT >> and press the PTK.
RH set 56 %
RH +/- 8 %
=> >> NEXT >>
You enter the next screen. Select "RH night".
=> RH night 60 %
NightDel 5 min
>> NEXT >>
Press the PTK and adjust setpoint for night mode.
Press the PTK to confirm.
To set the delay time, select "NightDel". Press the PTK.
RH night 60 %
=> NightDel 5 min
>> NEXT >>
Turn until the desired amount of minutes (up to 100
minutes). Press the PTK to confirm.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions

8.5 RH Min/Max

To read the measured RH minimum/maximum values,
select >> NEXT >> and press the PTK.
RH night 60 %
NightDel 5 min
=> >> NEXT >>
You enter the next screen:
RH Min 51 %
RH Max 59 %
Reset Min/Max
<< BACK <<
Select "Reset Min/Max" and press the PTK to reset.
If you press and hold the PTK for 5 seconds while the
main screen is displayed, the RH Min/Max values are also
reset and set to the actual measured value.
Select << BACK << and press the PTK to return to the
main screen.
8.6 CO level
2
To read the actual CO concentration, press the PTK
2
once while the main screen is displayed.
TMP = 26.1 C
RH = 51 %
=> CO2 = 653 ppm
To read the Min/Max values, select "CO2" and press the
PTK.
CO Min 592 ppm
CO Max 853 ppm
=> Reset Min/Max
<< BACK <<
Select "Reset Min/Max" and press the PTK to reset.
Select << BACK << and press the PTK to return to the
main menu.
13