Installation Of The Clima Eco Minimum Fan Speed; Operation Of The Clima Eco Minimum Fan Speed; Connecting Sensor; Control And Set The Clima Eco Minimum Fan Speed - TechGrow Clima Eco Minimum Fan Speed Handbuch

1. Installation of the Clima Eco

Minimum Fan Speed

1. Do not place the sensor to be connected in direct
sunlight nor in the direct airflow of fans, as this may
influence the measurements. The sensor must be
mounted at a height of +/- 1 meter above the floor.
2. Mount the TechGrow Clima Eco Minimum Fan
Speed on the wall with the supplied mounting kit.
3. Connect the sensor to the bottom of the Clima Eco
Minimum Fan Speed.
4. Put the plug of the fan into the outlet of the Clima
Eco Minimum Fan Speed.
5. Put the plug of the Clima Eco Minimum Fan Speed
into an electrical outlet.
6. Ready!
2. Operation of the Clima Eco
Minimum Fan Speed
The Clima Eco Minimum Fan Speed controls the
minimum fan speed to reach or keep the desired room

temperature.

The Clima Eco Minimum Fan Speed has 2 rotary knobs
to set the minimum fan speed and desired temperature
level. Hysteresis: 2 °C.
NOTE If no sensor is connected to the Clima Eco
Minimum Fan Speed, the fan runs continuously at
the set minimum speed.

3. Connecting sensor

The minimum sensor required is the TempProbe.
Always switch the controller off if you want to replace
the sensor.
4. Control and set the Clima Eco
Minimum Fan Speed
4.1 Minimum fan speed
After installing the Clima Eco Minimum Fan Speed the
fan starts to run (the fan must be on). Set the desired
minimum fan speed "Min Fan Speed" (10% – 100%) by
turning the left knob.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
4.2 Temperature
Turn the right knob to set the desired room temperature
"Temp" (15 °C – 35 °C).

4.3 Hysteresis

The hysteresis is 2 °C.

5. Meaning LED

The Clima Eco Minimum Fan Speed has an indicator LED.
Green: stable climate.
Red: high temperature.

6. Fuse replacement

If a short circuit occurs due to fan overload, the fuse will
blow. Even if the Clima Eco Minimum Fan Speed does
not operate at all, in the worst case, this could indicate a
blown fuse. To replace the fuse you have to open the
Clima Eco Minimum Fan Speed. Complete the following
steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Clima Eco Minimum Fan Speed.
3. Locate the fuse and remove it.
4. Insert a new 5 amp fuse.
5. Screw the 4 screws to close the housing.
Your Clima Eco Minimum Fan Speed is ready for use
again.
7