General Safety Instructions; Description Of The Controls; Start-Up Of The Device/Introduction; Instruction Manual - AEG mc 4401 cd Bedienungsanleitung

General safety instructions

To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
5....-05-MC 4401 CD AEG 31

Description of the Controls

1 POWER button (on/off)
2 REMOTE Sensor for the remote control
3 LED display
4 Station scale
5 CD compartment
6 STEREO control lamp
7 PUSH button to open the CD compartment
8 BASS on/off button
9 Band selector AM
10 Band selector FM
/ II CD Play/Pause button
11
I CD button forward search
12
13 PRO programming button
14 TUNING control
15 PULL fl ap
16 II Pause key - cassette
17 / Stop/Eject key - cassette
18 Fast Forward key - cassette
19 Fast Rewind key - cassette
20 Playback key - cassette
21 b Recording key - cassette
22 PHONES (headphone connection)
23 Cassette compartment
24 Loudspeakers
25 VOLUME
26 FUNCTION Function selector (RADIO/TAPE/CD)
27 RPT button
28 I
CD button reverse search
29 CD stop button
Reverse
30 Loudspeaker connections
31 Mains connection
32 FM throw-out aerial
Remote control
A I
SKIP/SEARCH button reverse search
/ II PLAY/PAUSE button
B
I SKIP/SEARCH button forward search
C
D REPEAT button
E STOP button
F PROGRAM button
G Battery compartment

Start-up of the device/Introduction

• Read the operating instructions thoroughly before the
start-up!
• Remove any transport safety equipment on the CD
and cassette sections.
• Select an appropriate location for the device, e.g. a
dry, fl at, non-slip surface on which the device can be
easily operated.
• Make sure that the device is adequately ventilated!
Connect the loudspeakers to the connections (30) on
•
the rear.
Power supply
• Insert the plug into a properly installed 230 V, 50 Hz
power socket. Please ensure that the mains voltage
corresponds to the information on the type plate.
Inserting the Batteries
(not supplied)
• Open the lid of the battery compartment (G) on the
back of the remote control.
31
11.02.2004, 11:54:48 Uhr