canadiana 1695890 Bedienungsanleitung Seite 18

Maintenance
Access the Spark Plug
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the ON/OFF key (A, Figure 15) or pull out the
ON/OFF switch or Push/Pull key. Keep the key away
from children.
2. Grasp the choke control (B) and pull up to remove.
3. Remove the mounting screws (C).
4. Carefully remove the top part of the snow hood (D). DO
NOT disconnect the primer hose (E) or the key wire (F).
5. Remove the spark plug (G) and replace. (See
Specifications).
6. Before installation of the snow hood, make sure the
primer hose and the key wire are connected.
7. Mount the top of the snow hood to the snow hood base.
Make sure the top interlocks with the base. Secure with
mounting screws .
8. Align the slots (H, Figure 15, Inset) in the choke knob
with the tabs on the choke shaft (I) and push down to
install. If knob is not installed correctly, the choke will
not operate.
9. DO NOT install the ON/OFF or Push/Pull key until you
are ready to start the engine.
18
Auger Cable Adjustment
Do not over-tighten, as this may lift the lever and cause the
auger drive to be engaged without depressing the auger drive
control.
The auger must stop within 5 seconds after releasing the con-
trol. If it does not, see an authorized dealer.
If the auger no longer turns when the control is engaged,
or if the belt slips under load, the auger cable or belt may
have stretched. This can be compensated for by adjusting
the auger cable. If the belt is too worn or broken, see your
authorized dealer for repair.
Notice: The auger must not turn unless the auger control
is engaged. The auger must disengage within 5 seconds
after the auger control is released. If it does not, see your
authorized dealer before further use.
Inspection
1. Start the engine.
2. Engage the auger control. The auger should turn.
3. Release the auger control. The auger should stop within
5 seconds.
If the auger does not turn or stop as indicated above,
perform the adjustment procedure, or take the unit to your
local authorized dealer for repair.
Adjustment
1. Turn off the engine and remove the key. Wait for all
moving parts to stop.
2. Slide the cable cover (A, Figure 16) up to expose the
cable adjustment loops (B) and Z-bend (C).
3. Disengage the cable Z-bend from the cable loops, and
install it in the next highest loop to increase belt tension.
Slide the cable boot back into place.
Note: There must be some slack in the cable when the
control is released.
4. Keeping clear of the auger, reinsert the key, start the
engine, and perform the Inspection procedure again. If
the auger does not turn or stop as indicated, take the
unit to your local authorized dealer for repair.
WARNING
WARNING