Assembly; Loop Handle Version; U-Handle Version - Shindaiwa T262XS Bedienungsanleitung

Before you start

Assembly

 Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.

Loop handle version

Loop handle assembly

U-handle version

U-handle assembly
WARNING
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
 Install the handle so that it does not hide any of the
safety decals.
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
E: Arrow
F: To engine
 Install the handle so that it does not hide any of the
safety decals.
3. To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
 After assembly, adjust the play of wire end (J) on carbu-
rettor (L) side to 1 mm - 2 mm.
K: Nuts
10
F: To engine
CAUTION
CAUTION
CAUTION