Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Boil-Dry Protection - Team wk 43 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Fax +32 2 359 95 50
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.

OPERATION

With automatic cut-off
Always remove the jug from the power base before filling it.
Raise the lid and fill the tank with fresh water paying attention not to fill under the minimum
mark and above the maximum mark in the kettle. You can see the level thanks to the
water level indicator inside the jug.
Put the temperature selector in MIN position.
Close the lid by pressing until you hear a locking click and make sure it is closed correctly.
Put the jug onto the base, plug into the wall socket and switch on. The pilot light situated
near the temperature selector will come on. If it does not come on, check if the jug kettle is
placed correctly on its base. If the problem persists, contact the nearest customer service.
The jug kettle will switch off automatically when the water has boiled. However, you can
switch it off anytime by pressing the switch.
Keep the lid closed when pouring the water in order not to get burned.
To boil water for a second time after your appliance has switched off automatically after
the first boiling process, wait until water has cooled down and switch on the appliance
again.
To open the lid, press its release mechanism and raise it.
With temperature control
Remove the jug kettle from the base before filling it with water.
Raise the lid and fill the tank with fresh water paying attention not to fill under the minimum
mark and above the maximum mark in the kettle. You can see the level thanks to the
water level indicator inside the jug.
Put the temperature selector in the desired position (other than MIN). The pilot light comes
on, indicating that the jug kettle is working. Do not press the switch.
When you put the temperature selector in a certain position, the temperature of the liquid
is maintained constant as long as the selector has not been moved and the appliance
has not been unplugged.
The maximum position corresponds to a temperature of approximately 70°C. When using
the temperature selector, water will not boil.
Caution: when pressing the switch, it cancels the operation of the selector and your jug kettle
will operate according to the automatic cut-off system (it will stop automatically when the
water boils).

BOIL-DRY PROTECTION

This jug kettle is protected with an automatic safety device if accidentally switched on
without water.
In this case, switch off the appliance and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will reset the safety device.
The kettle may then be used as normal. Should the problem persist, please contact the
nearest customer service.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/24
TEAM WK 43 - 060109

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis