Fax +32 2 359 95 50
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left from the
manufacturing process. When the appliance has cooled down, repeat the process at least 3 times with
fresh water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or before any operation.
Raise the lid and fill the tank with fresh water paying attention not to fill under the minimum
mark and above the maximum mark in the kettle.
Close the lid and make sure it closes correctly.
Put the jug onto the power base, plug into the wall socket and switch on. The jug kettle will switch
off automatically when the water has boiled.
For instant reboiling, wait until water has cooled down and switch the appliance on again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device if accidentally switched on without
water.
In this case, switch off the appliance and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset the safety device.
The kettle may then be used as normal.
CLEANING AND DESCALING
Before attempting any cleaning operation make sure the appliance is unplugged from the supply
socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly. On
no account must the jug kettle or its power base be immersed in water.
Do not allow heavy scale deposits to build up on the element. There are various preparations
available that remove scale without damaging your jug kettle.
Make sure to use a type recommended for plastic kettles.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don't change the page
numbering. Keep the languages integrity.
Assembly page 5/19
5