Appliance Overview; Handling Your Unit - Superior FK3-302A Bedienungsanleitung

• Regularly check the device, the power cord and the power plug for visible damage. Do not use the
device if you notice any damage. Do not attempt to repair the device yourself.
• Repairs may only be implemented by qualified repair personell.
• Use this device only on heat-resistant surfaces. Do not place the device near heat sources or open
flame.
• Use this device exclusively to boil water. Do not use the device to heat any other fluids (e.g. milk)
or to heat or boil foods.
• This device is intended only for private, non-commercial use.

APPLIANCE OVERVIEW

(1) Filter and spout
(2) Lid
(3) Lid release button
(4) Operating light/ On-Off switch
(5) Handle
(6) Water-level indicator
(7) Housing
(8) Base unit
(9) Power cable

HANDLING YOUR UNIT

Prior to using this device for the first time, we recommend cleaning it by boiling and discarding
water once as per the following instructions. This will remove any dust or residue remaining from
manufacture.
• Place the base station on a stable, level and heat-resistant surface. Please be sure that the device
cannot slide or tip over.
• Open the lid of the appliance by pressing the lid release button.
• Fill the tank with clear water. The water level must be between both water level marks (min./max.)
of your unit. The device can overheat if the water level is too low. Boiling water can splash out if
the water level is too high.
• Close the cover; the device will automatically switch off when the water boils only if the cover is
closed.
• Place the device on the base station and connect the power plug to a power outlet.
• Please be sure that the opening to pour fluids does not face toward a person as hot steam escapes
from this opening during boiling.
• Switch the main switch to "1", the control light will light up, indicating that the device is
functioning. The water will now be heated.
• Please be sure that the cover is tightly closed during boiling. Danger of Burns!
• After the water has come to a boil, the device will automatically switch off. The switch will jump
back to "0", the control light will go out.
• After heating the water, wait for a moment until the water no longer bubbles. Do not open the
cover during boiling or pouring.
• The heating process will be shut off immediately if the device is lifted from the base station. The
device will switch off.
• The water boiler is equipped with overheating protection. This will interupt the heating process of
the device if it is switched on without any water in the tank. In this case, the device must cool off for
at least 15 minutes prior to filling the tank with water and re-starting the heating process.
• Pull the power plug out of the power outlet if this device is not in use.
9 9