Introduction And General Description; Operating Directions - Masterflex 07571-52 Bedienungsanleitung

®
The MASTERFLEX E/S
Sampling Drives 07571-00 and 07571-05 in the field.
The MASTERFLEX Auxiliary Power Pack Kit consists of a fused, current-limited, rechargeable, sealed lead-acid battery
with a current limited charger and carrying pouch. The Power Pack plugs directly into the charger for recharging or
directly into the "External Power Input" port of the Portable Sampler to provide supplemental power for extended
operation of the Portable Sampling Drive.
To Charge the Auxiliary Power Pack
CAUTIONS: Fully charge the unit (8–12 hours) before using for the first time. Damage to the battery pack can
result if the battery is in a fully discharged state and operation of the unit is attempted.
The Power Pack (battery assembly) is continually powered. To prevent accidental shorting of the
coaxial plug, a protective cap is supplied with the unit. The protective cap should be installed
over the coaxial plug when the Auxiliary Power Pack is not in use. If this warning is ignored,
improper operation of this unit can occur.
WARNING: DO NOT use a battery charger other than the one supplied with
the power pack to charge the battery. If this warning is ignored,
damage to the unit and personal injury can result.
A. Remove the protective cap from the coaxial connector of the battery portion of
the Auxiliary Power Pack and mate it to the receptacle on the charger portion.
B. Connect the charger to an AC receptacle consistent with the voltage listed
on the charger.
C. Allow the unit to charge for 8–12 hours.
D. Disconnect charger from AC receptacle.
E. Disconnect battery from charger.
F. Reinstall insulating cap over coaxial plug.
CAUTION: Excessive charging of the battery will result in possible damage
to the unit and shortening of its useful life. Do not charge battery
for more than 24 hours.
Using the Auxiliary Power Pack to Run the Portable Sampler
A. Remove the protective cap from the coaxial plug of the power pack (battery) and
install connector into the EXTERNAL POWER INPUT of the drive.
B. Toggle the EXTERNAL/BATTERY switch to the EXTERNAL position.
C. Toggle the RUN/CHARGE switch to the RUN position.
D. Adjust drive controls for pumping direction and speed as desired.

INTRODUCTION AND GENERAL DESCRIPTION

®
Auxiliary Power Pack Kit is intended to provide supplemental 12V DC power to the Portable

OPERATING DIRECTIONS

2
JACK SHOWN WITH PROTECTIVE
CAP REMOVED.
Protective Cap