Weber Rescue Systems Stabfast MK2 ALU Gebrauchsanweisung Seite 11

Operation of individual components
Stabiliser strut
To extend
Ratchet
To unlock
To tension
To release
NOTE 'TO RELEASE'
This position only works if the strap is tensioned.
Neutral
To lock
Adjustable wedge
Lift up top. Fold out the short or long support and place against the stop. Open the eyelet by moving the pin
upwards and introduce the tie down strap.
IMPORTANT
Make sure the support is firmly against the stop.
Hook blade
Unfold the black brace and hook it behind a firm point.
*Place the blade with the tip on the metal plate. Pull the handle round.
NOTE
During cutting, always make sure that the brace does not slip.
Enlarge the incision created using the flat end of the hook blade handle.*
*NOTE
Keep the blade protected with the red cover cap.
The purpose of the hookblade is only to make incisions. Moving the tip of the hookblade sideways will it
cause to break. To enlarge the incision use the flat (back) end of the hookblade handle.
Stabiliser strut complete with 6 m green strap, hook and
red protective sleeve
Stabiliser strut complete with 6 m yellow strap, hook and
red protective sleeve
Stabiliser strut complete with 6 m blue strap, hook and red
protective sleeve
Adjustable wedge
Hook blade
Two carrying bags
Check wheter the lock on the telescopic strut is down in locked position.
Extend the telescopic strut to the desired length from the top.
Slide the telescopic strut in and out until it locks.
Check the lock.
Press the inner handle in and lift up one position.
Move the blue handle up and down (position 2).
Press the inner handle in and lift up one position (position 3).
Move the inner up and down.
Press the inner handle in and lift up one position (position 4). Place the tie down
strap, free pass-through, in a horizontal position, using the button.
Press the inner handle in and lower as far as it will go (position 1).
English | 11