INVENTO 500820-3318 Gebrauchsanleitung Seite 7

Operation of the boat
Place the boat gently into the water. In case of contact with water, the
2 contact points (fig. 6) will energize the boat (red LED of the boat
lights up). Keep boat and propellers clear of obstacles. Propellers are
a constant source of injury. Never touch moving propellers. The boat
is switched off once taken out of the water.
Transmitter functions (fig. 7 + 8)
(1) The red function indicator LED lights up when any button on the
transmitter is pressed.
(2) The boat runs forward/backward when the Forward/Backward button
is pressed.
(3) Pressing the Left/Right button on the transmitter while the boat is
running forward or backward, the boat will make left/right turns.
Function
indicator
light
Forward
Forward
Backward
ON/OFF
switch
Remove water from the boat
Caution: If the boat does not work properly, water might have penetrated the inside of the boat. Loosen the Phillips
screws located at the lower part of the boat (fig. 9), carefully separate the lower part from the upper part and dry it
with a hair dryer (fig. 10). Rescrew the boat again as last step.
fig. 9
fig. 7
Charge LED
Backward
Right
Left
7
Contact points
fig. 8
fig. 10
fig. 6