INVENTO 500820-3318 Gebrauchsanleitung Seite 6

Preparation
1. Remove the clear cover from the plastic
box (fig. 1). Then slide the charger cover to
the left together with the boat to separate it
from the transmitter (fig. 2).
2. Remove the screw on the cover as illustrated.
Turn the screw anticlockwise (fig. 3).
Charging the boat
Move the ON/OFF switch on the remote controller
to ON. Remove the charger cover from the
transmitter (slide cover to the left) and take
out the charging cable. Insert the charging plug
(notch on the plug faces towards the cone on
the charging socket) into the charging socket on
the boat (fig. 5). The green charge LED lights up
and will extinguish as soon as the boat has been
fully charged.
3. Use a Phillips screwdriver to open the battery
compartment cover. Insert 4 x 1.5V AA batteries
with the correct polarity and replace the battery
compartment cover (fig. 4).
Phillips screwdriver
(not included)
fig. 3
6
fig. 1 fig. 2
Battery Cover
fig. 5
4 x AA alkaline
battery (not
included)
fig. 4
Charging socket